MIMAKI JV300-160 A - Setting Leaf Media

2-7
2
2
2
5
6
Chapter 2 Basic Operation
12
Close the front cover.
13
Press the key to select “ROLL” .
• Detects the media width.
• When [MEDIA RESIDUAL] of the maintenance
function is “ON” ( P.3-13), the screen for
entering media remaining amount is displayed
after detecting the media width.( P.2-7)
Entering the media remaining amount
When [MEDIA RESIDUAL] of the maintenance function is
“ON” (
P.3-13), the screen for entering media
remaining amount is displayed after detecting the media
width.
1
Display the screen for entering media
remaining amount.
2
Press to enter the media
remaining amount.
3
Press the key.
About the media residual print
When [MEDIA RESIDUAL] of the maintenance function is
“ON” ( P.3-13), You can print a list of print the current
date and media remaining.
1
In Local, Press .
• It enters into the origin setting mode.
2
Press the key.
• Appear the confirmation screen of media
remaining print.
3
Press the key.
• Media residual print starts.
Setting leaf media
Unlike roll media, leaf media does not need to be retained
with the roll holders.
1
Open the front cover, and raise the clamp
lever.
2
Insert the leaf media between the platen
and the pinch rollers.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
3
Hold the media with the media press
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
Front cover
Front cover
Clamp lever
Pinch roller
Media press