MIMAKI JV300-160 A - Setting of Media Correction

3-5
1
2
3
4
5
6
Chapter 3 Setup
6
Press the key.
• Settings of Temporary will be saved to the location
selected in step 5.
7
Press the key several times
to end the setting.
Reset the registered contents
Reset the contents registered to SETUP 1 to 4.
1
Press the
(MENU)
key in
LOCAL.
2
Press to select SETUP 1 to 4 to
be reset and press the key.
• SETUP MENU will be displayed.
3
Press the (<<).
4
Press to select “RESET
SETTING”, and press the key.
• Confirmation screen of reset settings will be
displayed.
5
Press the key several times
to end the setting.
Setting of Media Correction
Correct the media feed amount to match the type of
media you are using.
If the correction value is not appropriate, stripes may
appear on the printed image, thus resulting in a poor
printing.
A pattern for media correction is printed and a media-
feeding rate is corrected.
1
Set a media. ( P.2-4)
2
Press the
(MENU)
key in
LOCAL.
3
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
4
Press to select “FEED COMP”,
and press the key.
5
Press the key twice to print a
correction pattern.
6
Check the correction pattern and enter a
correction value.
• A screen for entering the correction value will be
displayed.
• Enter a correction value in "+":
The boundary between the two bands is widened.
• Enter a correction value in "-":
The boundary between the two bands is
narrowed.
• When you change the correction value by "30", the
width of the boundary changes by about 0.1 mm.
7
Press the key.
• Print a correction pattern again and check it.
• When media correction is needed, perform the
operation in Step 6 to make correction.
8
Press the key several times
to end the setting.
Correcting Media-feeding during Printing
A media-feeding rate can be corrected even in the remote
mode or when image data is printed.
1
Press the
(ADJUST)
key
in the Remote.
2
Press to enter a corrected
feeding rate.
• Corrected feeding rate: -9999 to 9999
• The value entered here is reflected in the
corrected feeding rate soon.
3
Press the twice key.
• key. The changed value is registered.
• When you press the [ENTER] key instead of the
[END] key, the value entered here will be valid
temporarily.(When you perform media detection
again or turn the power OFF, the correction value
is cleared.)
• On completion of [MEDIA COMP.] during use of a roll
media, the media returns to the printing origin. Then the
roll media in the rear of this machine will slacken.
Before printing, take up the slack in the roll media by
hand; a loose roll media can result in an inferior image
quality.
• Two bands are printed in the correction pattern.
• Make adjustment so that an even color density is
obtained in the boundary between the two bands.
Second band
First band
Media feed direction