viii
1
2
3
4
5
6
Safety Precautions
Cautions on Installation
Safety interlock
This machine is equipped with interlocks to terminate the
operation for your safety when the cover opens during
printing etc. (red circle parts in the figure below).
Handling of ink cartridges
• Safety is evaluated by our recommended ink. Please use
our recommended ink for safe use.
• If the ink cartridge is moved from a cold place to a warm
place, leave it in the room temperature for three hours or
more before using it.
• Open the ink cartridge just before installation. If the ink is left
open for a long time, normal printing performance may not
be ensured.
• Make sure to store ink cartridges in a cool and dark place.
• Keep ink cartridges and waste ink tank out of reach of
children.
• Be sure to thoroughly consume the ink cartridge within 3
months after opening it. If it has passed for a long time after
opening, the print quality would be poor.
• When you no longer need ink cartridges, ink packs, and
waste ink, please hand them over to your distributor or
service representative. If you dispose them by yourself,
please followthe regulations stipulated by the industrial
waste disposer or the local regulations of each country.
• Do not hit the ink cartridge strongly or shake it violently. Ink
may leak from the cartridge.
• Do not refill ink in the ink pack or ink cartridge. We are not
responsible for any problems caused by using refilled ink.
• Do not touch or stain the contact area of the ink cartridge
PCB. It may cause a PCB failure.
Handling of media
• Use recommended media.
Use our recommended media to print with stable and high
image quality.
• Pay attention to the expansion and contraction of the media.
Do not use media that has just been opened. The media
may expand and contract depending on the room
temperature and humidity. Open the package and expose it
to the place of use for at least 30 minutes before attaching it
to the unit.
• Do not use curled media.
In addition to causing media jams, it also affects the image
quality.
Also, use media with tight curls after removing the curls. If a
regular-sized coated sheet of media is rolled and stored, the
coated side has to face outside.
Disposition of this machine
• Consult your sales or service representative for proper
disposal of this machine. Otherwise, commission an
industrial waste disposal company.
A place exposed to direct
sunlight
On an inclined surface
A place that vibrates
A place exposed to direct air
flow from an air conditioner
or the like.
A place where temperature or
humidity varies significantly
Around a place where fire
is used
• Use the machine under the
following environmental
conditions:
• Operating environment:
20 to 30 °C
(68 to 86 °F)
35 to 65 % (Rh)
To Next Page
Loading...
