3-7
1
2
3
4
5
6
Chapter 3 Setup
Setting of Logical Seek
The head’s operation varies depending on the LOGICAL
SEEK settings, as shown in the figure below.
1
Press the
(MENU)
key in
LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press to select “LOGICAL
SEEK”, and press the key.
4
Press to select a set value, and
press the key.
• Set value : HOST / ON / OFF
5
Press the key several times
to end the setting.
Setting of Drying Time
In the drying time setting, the following items for ink drying
time are set.
• SCAN : Ink drying time for each scanning is set. (During
bidirectional printing, the machine stops for a
certain period of time specified for each of the
outward and return scanning.)
• PRINT END : Ink drying time after printing has been complete
is set.
1
Press the
(MENU)
key in
LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press to select “DRYING TIME”,
and press the key.
4
Press the key.
5
Press to set drying
time, and press the key.
• Set the drying time for canning and after printing
is completed. To enable the drying time specified
in your RIP, select “Host”.
• Scanning setting value :
Host or 0.0 sec. to 9.9 sec.
• Print end setting value:
Host or 0 sec. to 120 min.
• Item selecting : by the [][] keys
• Time setting : by the [][] keys
6
Press the key several times
to end the setting.
UNI-DIRECTIONAL BI-DIRECTIONAL
Movement of heads when LOGICAL seek is OFF
Movement of heads when LOGICAL seek is ON
UNI-DIRECTIONAL BI-DIRECTIONAL
Media
Red arrow :
Movement of head
Print erea
Red arrow :
Movement of head
Print erea
Media
Media Media
• When you give priority to the setting at the
RasterLink side, make the setting value “Host”.
• “SCAN” set in this machine is displayed as “Pause
Time per Scan” in the RasterLink.
• You cannot specify the print end at the RasterLink
side. When you set this machine to “Host”, printing
will be performed in “PRINT END= 0 min.” status.
To Next Page
Loading...
