MIMAKI JV300-160 A - Automatic Remote; Initializing the Settings

Chapter 3 Machine setting
3-19
1
2
3
4
5
6
Automatic remote
 Applicable model: Plus series (FW Ver.1.30 or
later)
When data is received in local mode, it automatically
switches to remote mode and starts printing.
1
Press
(MENU) (twice
)
key in local mode.
• MACHINE SETUP MENU will be displayed.
2
Press (>>)
.
3
Press to select "Auto Remote",
then press the key.
4
Press to select "ON/OFF", then
press the key.
• ON: When data is received in local mode, it
automatically shifts to REMOTE and starts
printing.
• OFF: Remote transfer by pressing.
5
Press the key several times to
end the setting.
Initializing the Settings
You can return the setting of “SETUP”, “MAINTENANCE”
and “MACHINE SETUP” to the status before shipment.
1
Press the
(MENU) (twice)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press the
(>>)
.
3
Press to select “RESET”, and
press the key.
4
Press the key.
• The already configured settings are initialized.
5
Press the key several times
to end the setting.