Overhaul of Driving Parts
3-43
5
Remove the screws (x2), and remove the
wiper assembly from the base.
6
Release the clamp from the lower part of
the station, and remove the connector
that is directly connected to the wiper
motor.
7
Remove the wiper home position sensor
connector.
8
If you are replacing only the motor,
remove the wiper drive link and remove
the screws (x2) to remove the motor.
* When replacing the motor, create a gap of 0.5
mm between the motor and the base.
9
Reattach by reversing the removal pro-
cedure.
To Next Page
Loading...
