Functions
2-33
SENSOR TEST
Various sensors are tested.
Before starting the test, turn the servo motor and stepping motor to OFF, after finishing the test, initial
operation of original position detection is executed.
OPTION
Connection check of all optional devices.
TAKE-UP: winding device
EXHAUST: exhaust fan
DRYER: dry fan
“OFF” when not connected, and “ON” when the respective device is connected in the correct location.
KEYBOARD LED
ON/OFF test of the keyboard LEDs.
Heater LEDs: Pre, Print, and After heat LEDs
ACTIVE LED
Controls the LEDs above according to the ON/OFF designation.
<Sensor test>
Sensor Content LCD display
SET LEVER State display of clamp lever sensor ON/OFF
R.PAPER State display of rear paper sensor ON/OFF
Y-ORIGIN State display of Y-original position sensor. ON/OFF
WIPER State display of wiper sensor ON/OFF
FRONT COVER State display of cover sensor (front, maintenance LR) ON/OFF
HEAD HEIGHT Displaying the state of head height sensor ON/OFF
Since the shape of all the connectors is the same, they can be connected anywhere.
However, if they are connected in the wrong place, the devices will not work.
To Next Page
Loading...
