Overhaul of Other Parts
3-45
3-7-1. Cutter Unit Assembly
Content
A summary of the series of operations to perform when replacing the cutter assembly is described along with
the procedure.
Remove/Install Cutter Unit Assembly
1
Turn the main power supply on the right
side panel of the printer ON, then select
[MAINTENANCE] - [ST.MAINTE-
NANCE] - [CARRIAGE OUT] to move
the head unit over the platen.
2
Turn the main power supply off.
3
Remove the front cover (x4 screws), Y cover C (x4 screws), and the head cover (x2 screws). (See
P.3-4 )
Item Description
Reference
page
1. Remove/Install Cutter Unit
Assembly
Replace the cutter assembly.
p.3-45
2. Adjust the cutter attachment
position
Use the height adjustment jig to adjust the up/down/left/right attachment
positions.
p.3-46
Be sure to shut the main circuit breaker to prevent unexpected movements.
Power ON.
<LOCAL.1> [#01] FUNCTION
MAINTENANCE <ent>
[FUNC]
Execute Car-
riage out
ST.MAINTENANCE
CARRIAGE OUT <ent>
MAINTENANCE
ST.MAINTENANCE <ent>
To Next Page
Loading...
