MIMAKI JV33-160 - 2-2-4. PARAMETER Function; System Parameter Initialization; Maintenance Parameter Initialization; Customize Parameter Initialization

Functions
2-39
System Parameter Input Mode
Starts the device in system parameter input state of #PARAMETER function.
This function is for initializing parameters when starting of device is disabled to start because of
parameter hash error and so on.
Starting method: Starts with pressing [] + [] (Or starts with pressing
[ENTER] + [END] ).
2-2-4. PARAMETER Function
PARAMETER function is a function to confirm and set parameters in the device.
Note: While accessing F-ROM and HEAD.EEPROM, display [F-ROM WRITING] and light up BUSY LED (red).
No.1~6: Default selection is allowed
No.7~14:Selection is allowed only at the maintenance open
<Parameter function item>
No. Item Stored place Notice
1 SYSTEM PARAM. F-ROM sector 2
2 MAINTE PARAM. F-ROM sector 2
3 CUSTOM PARAM. F-ROM sector 2
4 RUNNING PARAM. F-ROM sector 1 /Backup SRAM
5 EXCHANGE PARAM. F-ROM sector 2
6 INKSYSTEM PARAM F-ROM sector 2
7 INKinfor.PARAM. F-ROM sector 2,8,9
8 INKSEQUENCEpara F-ROM sector 2,8,9
9 INKTYPE PARAM. F-ROM sector 2,8,9
10 HEADunit PARAM. F-ROM sector 1 /Backup SRAMHEAD.EEPROM
11 SERVO PARAMETER F-ROM sector 2
12 TEST PARAMETER F-ROM sector 2
13 CORRECT PARAM. F-ROM sector 2
14 ADJUST PARAM. F-ROM sector 2