MIMAKI JV33-160 - Page 131

Troubles for which error messages are displayed
4-9
ERROR
211
HeaterTEMP
(--/--/--)
An abnormal tempera-
ture of the media heater
is detected.
Turn the main power OFF and turn the
main power ON after elapse of 2~3
minutes. In a case of recurrence, con-
tact your local distributor to call for
service.
1. Replace the main PCB with a new one.
2. Replace the power supply PCB with a new
one.
3. Replace the corresponding platen cover
with a new one.
HeadWARM.
TEMP. (----)
An abnormal tempera-
ture of the head heater
was detected.
1. Make sure that the connection to the main
FPC is correct.
2. Replace the corresponding head heater
with a new one.
3. Replace the ink slider PCB with a new
one.
HeadWARM.
BREAK(----)
The head heater is dis-
connected.
HeadWARM.
THERM(----)
Trouble has occurred
with the thermistor of
the head heater.
ERROR
250
Y COORDI-
NATES
An error was detected
during scanning opera-
tion.
Turn the main power OFF and turn the
main power ON after elapse of 2~3
minutes. In a case of recurrence, con-
tact your local distributor to call for
service.
1. Make sure that the position of media is
correct.
2. make sure that there is no bend on the
Paper width sensor.
3. When the state is not recovered, check
parameter upload and using state, and
report the result to the development
department.
ERROR
251
SYSTEM ERROR A system error occurred. Turn the main power OFF and turn the
main power ON after elapse of 2~3
minutes. In a case of recurrence, con-
tact your local distributor to call for
service.
1. Confirm the error with memory check
(Main.FROM).
2. When the state is not recovered, check
parameter upload and using state, and
report the result to the development
department.
<Error messages and corrective measures (continued) >
Display
Cause
Remedy (instruction & maintenance manual)
ERROR
No.
ERROR
Descriptions in the manual
(for reference)
Remedy