MIMAKI JV33-160 - Page 81

Overhaul of Ink-related Parts
3-11
Drop Position Correction
1 Select “DROP.POS ADJUST” from the
operation menu.
2 Select a scan speed for the standard.
Select standard or high-speed depending on the
usage conditions.
* The factory default is “high-speed”.
3 Select the resolution for standard.
* DRAFT :540dpi
FINE :720dpi
* Adjusts all of DRAFT, FINE, DRAFT2, and
FINE2.
4 Print the “Y return” and “Fine Y
return” in order.
After adjusting the Y return, perform fine
adjustment of the fine Y return.
5 Check the pattern.
 Y Bi
Check the overlapping parts of the pattern on
the outward and return paths.
 Fine Y Bi
Only D raw is used for the pattern drawing. Use
the scope and adjust where the two lines over-
lap.
Adjusting value: -50~50.0 dot (unit: 0.1 dot)
6 Enter the adjustment value.
Power ON. <LOCAL.1> [#01] FUNCTION
#ADJUST <ent>
[FUNC]
#HEAD ADJUST
DROP.POS ADJUST<ent>
#ADJUST /PRINT
HEAD ADJUST <ent>
#DROP.POS. MODE
SELECT :HiSPEED SCAN
[]/[] : For Scan Speed
[ENTER] : Fix (to Next)
:Normal SCAN
#DROP.POS. HsLg
SELECT :DRAFT
:FINE
:DRAFT2
:FINE2
[]/[] : For Resolution
[ENTER] : Fix (to Next)
#DROP.POS.HsLgDRFT
ADJUST :Y Bi
#DROP.POS.HsLgDRFT
Y Bi DRAW :ent
Adjust pat-
tern drawing
:FINE Y Bi
[]/[] : SW
Compensation
Value
Return
Path
Out-
ward
Path
#DROP.POS.HsLgDRFT
Y Bi : *.0