Overhaul of Driving Parts
3-29
Removing/Installing the X-axis motor assembly
1
Turn the main power supply of the printer off.
2
Remove Left Cover. (See P.3-5 )
3
Remove the screws (x2) attached to the
XM bracket.
4
Remove the X-axis motor connector.
5
Remove the spring, and remove the XM
bracket and X-axis motor from the main
unit.
6
Remove the screws (x3) attached to the
XM bracket, and remove the X-axis
motor assembly.
7
Reattach by reversing the removal procedure.
Be sure to shut the main circuit breaker to prevent unexpected movements.
The belt tension does not need to be adjusted.
To Next Page
Loading...
