4-58 BeneLink Module Operator’s Manual
Monitor output: alarms from Hamilton G5 (Block Protocol) Ventilator
Priority Label
Low
Low
Technical
alarm
Check PEEP/high pressure limit
Check PEEP/Pcontrol
Check PEEP/Psupport
Check P-ramp
Check trigger
Check %TI
Check pause
Check I:E
Check Vt
Check rate
Check peak flow
Check TI
Check Flow Pattern
Flow sensor calibration needed
Expiratory valve calibration needed
Apnea ventilation ended
Maximum leak compensation
Low ExpMinVol alarm off
CO2 sensor calibration needed
Check CO2 airway adapter
CO2 sensor disconnected
CO2 sensor over temperature
CO2 sensor faulty
External battery empty
Sensor simulation active
IRV
Cuff leak
IntelliCuff not found
Check VThigh limit
AERONEB module disconnected
Oxygenation adjustment OFF (no SpO2)
To Next Page
Loading...