BeneLink Module Operator’s Manual 4-57
Monitor output: alarms from Hamilton G5 (Block Protocol) Ventilator
Priority Label
Med
ium
SpO2: po
or signal (left slot)
SpO2: poor signal (right slot)
Large change in FiO2
Recruitment maneuver in process
Brightness test alarm
AERONEB disconnected
Cuff disconnection
Air + heliox supplies failed
Oxygenation adjustment OFF (no SpO2)
Ventilation adjustment OFF (no PetCO2)
No hemodynamic status available
High HLI
MV oszillation
FiO2 oszillation
PEEP oszillation
Cuff high pressure
FiO2 set to 100% due to low saturation
Check P ramp
Low
Low
T
echnical
alarm
If the monitor shows the alarm [Low Technical
alarms], the external device has one or more of the
following alarms:
Volume Low for nebulizer
ASV: Check high pressure limit
APV: Check high pressure limit
Pressure low limit reached
Check %MinVol
Check Body Wt
ASV: Cannot meet target
Medium
Technical
alarms
To Next Page
Loading...