Safety Precautions 1-5
1.3.2 Mechanical safety
WARNING:
1.
Before moving the system, please hold the handle. If other parts
of the system are held, it may cause damage due to the
abnormal force. Do not push the system from the left/right side;
otherwise, it may be toppled over.
Do not subject the transducers to knocks or drops. Use of a
defective probe may cause electric shock to the patient.
CAUTION:
1. Fasten and fully secure any peripheral device before moving
the system, gently and carefully move the system to avoid
falling over.
2. Do not expose the system to excessive vibration (during the
transportation) to avoid device dropping, collision, or
mechanical damage.
Please install the system on a flat plane with the four casters
locked. Otherwise, damage may be resulted by accidental
moving.
Pay extra attention when moving the system on a sloping
ground, do not move it on a more than 10°-sloped plane to avoid
system toppling.
5. Move the system ONLY WHEN the system is shut down or in
standby status, otherwise the system hardware disk may be
damaged.
1.3.3 Personnel Safety
NOTE:
1.
The user is not allowed to open the covers and panel of the system, neither
device disassemble is allowed.
2.
To ensure the system performance and sa
fety, only Mindray engineers or
engineers authorized by Mindray can perform maintenance.
Only technical professionals from Mindray or engineers authorized by Mindray
after training can perform maintenance.
1.3.4 Other
NOTE:
For detailed operation and other
information about the ultrasound system, please
refer to the operator’s manual.
To Next Page
Loading...
Need help?
General
