Mindray DC-70 Pro User Manual

6-6 Software Installation &Maintenance
3. Select [System and Security], and then select [System].
4. Check the activation status. If Windows 10 is not activated, close Windows Explorer to return to
the ultrasound screen.
If the “Activate Windows” button is displayed on the screen, as shown in the above figure,
Windows 10 is not activated.
5. Navigate to [Setup] > [Maintenance] > [Setup] and click [Enable ms-setting].
6. Select [OK] > [Save] to exit and power off the system.
7. Power on the system, and redo steps 1-3.
8. Click [Activate Windows]. It may take a while to activate Windows. After it is successfully
activated, “Windows is activated” will be displayed on the screen as shown below.

Mindray DC-70 Pro Specifications

General

Touch Screen	Yes
Touch Panel	Yes
Transducer Ports	4
Battery Backup	Yes
3D/4D Imaging	Yes
Operating System	Windows-based
Power Supply	100-240V AC, 50/60 Hz
Storage	500GB HDD
Connectivity	USB, HDMI
Applications	Cardiology, Obstetrics, Gynecology
Imaging Modes	Color Doppler, Power Doppler
Ports	USB, Ethernet, HDMI
Display Size	19 inch