10-12 System Diagnosis and Support
types of tests: production self-test, maintenance self-test and user self-test. This chapter
describes the maintenance self-test and user self-test in details.
10.4.2 Operation Procedure of Maintenance Self-test
Note: Before entering system self-test, all tasks running on Doppler should be completed,
otherwise the self-test system fails to respond. It is recommended to start self-test
software to perform the test after the system is generated.
1. Switch account, type service password and service account to log in.
2. Select [Setup]-[Maintenance]-[Setup].
Click [Self Test] out of dialog box.
Note: If the system is in Chinese, the self-test performs Chinese system self-test.
If the system is not in Chinese, the self-test performs English system self-test.
To Next Page
Loading...
