System Installation 3-25
IP Config
When the system background is processing network task (DICOM sending for example),
please do not enter network setting to change the IP, otherwise the background task may
fail. You can check if there are tasks undergoing in the task manager.
IP config is used for setting local network parameters, which is also applied to DICOM connection.
1. In Wireless network manager screen, click [IP Config] to open the page:
If “DHCP” is selected, the IP address will be automatically obtained from the DNS server.
If “Static” is selected (using a static IP address), enter the IP address.
IP address of the system should be in the same network segment with the server.
Subnet Mask: set different network segment.
Gateway: set the gateway IP.
2. Click [OK] to save current setting. Click [Cancel] to exit.
If the IP address displays as 0.0.0.0, this means that the network is abnormal. The
reason for the failure may be disconnection or the system cannot obtain the IP address.
EAP Network (for Windows 7 system)
EAP (Extensible Authentication Protocol) is an authentification frame protocol that supports multiple
authentification methods. It is mainly used for network access authentification, and is applicable for
wireless enterprise security authentification.
1. In Wireless Network Connection screen, click [Eap Network] to open the page:
To Next Page
Loading...
Need help?
General
