Laser Printer Reports Reports
20 - 12 V Series Operating Instructions
Printing the Standard Report
1. Select the Procedures tab from the Navigation Area.
2. Select the 12 Lead button.
3. Select the Advanced tab.
4. Select Standard from the Report Format button.
5. Select the Accept button to save the setting and close the dialog.
6. Select the Procedures tab from the Navigation Area again.
7. Select the 12 Lead button.
8. Select the Print 12 Lead button.
The report prints.
NOTE: If the ECG Management system is configured On, the 12 Lead
interpretation as XML format will be exported to the specified file path.
Refer to "Configuring ECG Management Setup" on page 26-16 for
additional information.
NOTE: If there are any errors detected while exporting the 12 Lead
Interpretation, the system displays an error message.
20.5.2.2 Representative Complexes and Matrix Report
This report includes three pages: the Standard page, the Representative Complexes page, and the
Measurement Matrix page (as shown FIGURE 20-6, FIGURE 20-8, and FIGURE 20-9).
To Next Page
Loading...
Need help?
General
