Mindray VS-900 - Upgrading Parameter Modules

8-2
Upgrade
package
Description of upgrade
package
PN of upgrade
package
Remarks
connector
Not
e: measurement accessories are not included in the above upgrade packages.
8.1.2 Upgrading Parameter Modules
8.1.2.1 Upgrading Mindray SpO
2
and Nellcor SpO
2
List of upgrade package:
 A Mindray SpO
2
board or Nellcor SpO
2
board;
 An SpO
2
insulator;
 A connector panel assembly for Mindray SpO
2
board or Nellcor SpO
2
board; and,
 Two M3×6 screws
1. Remove the power management board and connector panel assembly as described in
6.3 Disassembling the Main Unit.
2. Assemble the SpO
2
board and insulator onto the power management board as
described in 6.3.7 Removing the Parameter Board (SpO2 Optional) and Power
Management Board.
3. Install the power management board assembly with the SpO
2
board and the connector
panel assembly in the service kit into the main unit as described in 6.3 Disassembling
the Main Unit
.
8.1.2.2 Upgrading Masimo SpO
2
List of upgrade package:
 A power management board assembly with Masimo SpO
2
; and,
 A Masimo SpO
2
connector panel assembly.
1. Remove the power management board, connector panel assembly and the stopple of
multifunctional connector (if there is one) as described in 6.3 Disassembling the Main
Unit.
2. Install the power management board assembly with the SpO
2
board and the connector
panel assembly in the service kit into the main unit as described in 6.3 Disassembling
the Main Unit.