Mindray VS-900 - Removing the Parameter Connector Panel Assembly

6-9
3. Unscrew the two M3×6 screws and take out the power management board assembly.
6.3.8 Removing the Parameter Connector Panel Assembly (With CO
2
)
1. Lay the rear housing assembly of the equipment on a table.
2. Pull out the AC receptacle, SpO
2
cable, and then the silicon tube, gas inlet tube, gas
outlet tube and CO
2
connection cable.
Power management board
2 M3 screws
Parameter connector panel assembly
SpO
2
signal
cable
Gas inlet tube
CO
2
connection
cable
Gas outlet tube
Silicon tube