Mindray VS-900 - Recorder Failures; Output Interface Failure

5-5
5.6.7 Recorder Failures
Symptoms Possible Cause Troubleshooting
No printout
Recorder module
disabled
1. Check if the recorder status indicator lights.
2. If yes, select
[Main
→
][Maintenance >>
→
][Factory
Maintenance >>
→
] enter the required
→
password [Ok
→
][Device Config >>] and check the
recorder box in the prompt menu to enable the
recorder. Otherwise, check for other possible causes.
Paper reversed Re-install the paper roll.
Cable defective
1. Check that the cable between the recorder and
main board is correctly connected.
Recorder defective Replace the recorder.
Poor print
quality or
paper not
feeding
properly
Paper roll not properly
installed
Stop the recorder and re-install the paper roll.
Print head dirty
1. Check the thermal print head and the paper roller
for foreign matter.
2. Clean the thermal print head with an appropriate
clean solution.
Recorder defective Replace the recorder.
5.6.8 Output Interface Failure
Symptoms Possible Cause Troubleshooting
Unable to use the
USB devices; USB
drive data transfer
failure
Cable defective
1. Check that the cable between the power
management board and main board is correctly
connected.
2. Check that the cable between power
management board and interface board is
correctly connected.
The connector board
failed.
Replace the connector board .
Power management
board defective
Replace the power management board.
The main board failed. Replace the main board.
Improper setup
Select [Main
→
][Transfer Data >>
→
][Transfer
Data to USB]