Mindray VS-900 - Upgrading Touchscreen; Upgrading Recorder Function

8-4
1. Install the Wi-Fi module onto the main board and then connect the Wi-Fi antennas as
described in
错误 ! 未找到引用源。 错误 ! 未找到引用源。 .
2. Paste the Wi-Fi label.
3. Select [Main
→
][Maintenance >>
→
][User Settings >>
→
] enter the required
→
password [Ok
→
][Network >>].
4. In the Network Setup menu, set [Network Type] to [WLAN]. Set the wireless network as
described in the Network section in the Operator's Manual.
5. Try to connect the equipment to a nearby wireless network and see if the connection
succeeds.
8.1.7 Upgrading Touchscreen
List of upgrade package:
 A front housing assembly service kit for VS-900 (Touchscreen, without main board)
1. Disassemble the main board and cables from the front housing, and install them to the
front housing with touchscreen as described in 6.4 Disassembling the Front Housing
Assembly.
2. Assemble the front housing assembly and rear housing assembly as described in 6.3
Disassembling the Main Unit.
3. Select [Main
→
][Maintenance >>
→
][Factory Maintenance >>
→
] enter the required
→
password [Ok
→
][Device Config. >>]. Check the touchscreen function in the menu to
enable the software. Then restart the equipment.
8.1.8 Upgrading Recorder Function
1. Pry the recorder cover on the left side of the monitor with a little screwdriver, and take
out the metal sheet used to seal the recorder as described in 6.3.3 Removing the
Recorder. Then install the recorder assembly.
2. When the recorder is installed, select [Main
→
][Maintenance >>
→
][Factory
Maintenance >>
→→
] enter the required password [Ok
→
][Device Config >>]. Check
the recorder option in the menu to enable the software. Then restart the equipment.