8-8
8.2.2 Software Upgrade Procedure
Check the version of the software to be upgraded as described in 4.9.3 Software Version
before upgrade.
1. Connect the monitor to be upgraded and a PC running the upgrade tool to the same
network, or directly connect the monitor and the PC via a crossover network cable.
2. Set the IP address of the PC to "77.77.1.XX" and subnet mask to "255.255.255.0".
3. Run Mindray Patient Monitor Software Upgrade Tool on the PC and set Machine to
[Vital sign].
4. On the Mindray Patient Monitor Software Upgrade Tool screen, select [Select Package]
and then the packages you want to upgrade. Then select [Start].
5. Turn on the monitor to be upgrade. Press and hold
(Silence) and (Admit
Patient) buttons for 2 to 3 seconds, the monitor enters upgrade mode and starts
software upgrade automatically, and corresponding prompt messages are displayed on
both the monitor and PC.
When software upgrade is finished, restart the monitor and check if the software is correctly
upgrade.
For details of software upgrade, please refer to help and instructions for use of Mindray
Patient Monitor Software Upgrade Tool.
CAUTION
Disconnect the equipment from the patient and make sure the important data are
saved before upgrade.
Do not shut down or power off the equipment when upgrading the system software.
Otherwise, it may cause the equipment to break down.
Software upgrade should be performed by qualified service personnel only.
Crossover network cable is recommended when a PC is connected for software
upgrade.
NOTE
Make sure the version of the upgrade package is what you desired. To obtain the
latest upgrade package, please contact Mindray Customer Service Department.
To Next Page
Loading...
