Getting to Know Your Copier
2
Di251/Di351 2-29
2.6 Connecting the Copier
The copier needs a reliable, consistent power supply. Please call your in-
house technical support if required.
The allowable values for the power supply and the frequency range can
be found in the technical information. For more information, see page 8-7.
2.7 Switching the Copier On and Off
Switching the Copier On
Ü Press the power switch to the ON
position.
The [START] indicator key on the
control panel is red.
After a few seconds the following
message is shown on the touch
screen:"Now warming up. Ready to
scan".
After switching on the copier, all functions are at their default settings.
When the copier is shipped, the following default settings apply:
l Number of copies: 1
l Paper Feed: Auto Paper Mode
l Zoom Factor: ×1.000
l Exposure: Auto Exposure Mode (Text Mode)
l Finishing: Non-sort
l Copy mode: From 1-sided original to 1-sided copy.
You can change the default settings in the User's Choice. For more
information, see page 6-1 and the following pages.
ON
OFF
To Next Page
Loading...
