Minolta Di251 - Stopping the Copy Cycle; Resetting Copier Settings

Initial Steps . . .
3
Di251/Di351 3-7
3.7 Stopping the Copy Cycle
Stop a copy cycle to prevent further output of faulty copies.
1
Press [STOP].
The copy cycle stops.
2
Press [C] on the control panel.
The printing job is deleted. The
copier settings are left unchanged.
3.8 Resetting Copier Settings
Reset the copier to the default settings.
Ü Press [RESET] on the control panel
of the copier.
The copier is reset to the default
settings.
.
Changing the default settings
You can change the default settings of the copier. For more
information, see page 6-2.