Minolta Di251 - Placing Copy Paper Onto the Single Feed Tray

2
Getting to Know Your Copier
2-48 Di251/Di351
Placing Copy Paper onto the Single Feed Tray
Use the single document feed tray to feed individual copy sheets, for
example of special paper, into the copier.
1
Load the original into the document feeder. If necessary, make
additional copier settings.
2
Lower the single feed tray.
3
Set the guide plates for the copy
paper width.
4
Place the copy paper directly onto
thetray.Thesidethatistobe
printed must be down.
5
Specify the paper size for type.
For more information, see
page 4-13.
6
Start the copy cycle by touching
[START].
?
Does each copy cycle have to be restarted for multiple copies?
Ü No. The copy cycle needs to be started only once. The subsequent
copy paper is fed in as it was loaded.
Note the following important information!
Capacity: 1 sheet
Types of paper: Plain paper, recycled paper (60g/m
2
up to 90g/m
2
)
Thick paper (91g/m
2
up to 160g/m
2
)
OHP transparencies, labels
Paper sizes: max. size 297× 432 mm
min. size 90 × 140mm