Minolta Di251 - Checking Copier Settings; Entering the Number of Copies

Initial Steps . . .
3
Di251/Di351 3-5
3.3 Checking Copier Settings
Check the copier settings before starting a complex copy cycle.
1
Press [MODE CHECK] on the
control panel.
An overview of the current copier
settings is shown.
2
only if necessary
Touch a key to change the
corresponding setting.
3
Press [EXIT] to confirm
the copier settings.
The basic settings are shown again.
3.4 Entering the Number of Copies
Input the number of copy sets that you wish to make from your original.
Ü Touch the corresponding keys on
the numeric keypad.
The number of copies is shown on
the touch screen in the upper right-
hand corner.
?
Did you enter an incorrect
number?
Ü Press [C] on the control panel.
Enter the number of copies
again.