Minolta Di251 - Using Memory Recall

Initial Steps . . .
3
Di251/Di351 3-17
3.11 Using Memory Recall
Print a copy job once more after the copy cycle is finished without having
to reload the original. Use memory recall for this.
The “Memory Recall“ function must be enabled in the User's Choice
settings. Only if it is enabled is the key shown on the touch screen. For
more information, see page 6-5 and the following pages.
Memory recall is not available if:
l The copier has been switched OFF.
l New originals have been scanned.
l The [START], [KEY], [C] or [INTERRUPT], [SCAN MODE],
[USER'S CHOICE] keys have been pushed.
1
Press [MEMORY RECALL].
The display will change.
2
Press[C] on the control panel. Set a
different number of copies with the
numeric keypad.
or
Press [START] to start printing.
.
Delete the data before leaving the copier!
Before leaving the copier, for security reasons you should touch
[RESET] to delete the data in memory.