126
DATA-TRANSFER MODE
CONNECTING TO WINDOWS 98
The driver needs only to be installed once. If the driver cannot be installed automatical-
ly, it can be installed manually with the operating system’s add-new-hardware wizard;
see the instructions on the following page. During installation, if the operating system
requests the Windows 98 CD-ROM, inset it into the CD-ROM drive and follow the
accompanying instructions on the screen.
Before connecting the camera to the
computer, place the DiMAGE soft-
ware CD-ROM in the CD-ROM
drive. The DiMAGE installer menu
should automatically activate. To
automatically install the Windows 98
USB driver, click on the starting-up-
the-USB-device-driver-installer but-
ton. A window will appear to confirm
that the driver should be installed;
click “Yes” to continue.
When the driver has been success-
fully installed, a
window will
appear. Click
“OK.” The cam-
era can now be
attached to the
computer (p. 124).
AUTOMATIC INSTALLATION
To Next Page
Loading...
