Mitsubishi Electric MELSEC iQ-R-R00CPU - Page 1013

APPX
Appendix 15 Added and Enhanced Functions
1011
A
*1 The R00CPU is excluded.
*2 This indicates the compatible software version of GX LogViewer.
*3 Step relays (BLn\Sn) can be specified with CPU Module Logging Configuration Tool or GX LogViewer.
*4 This indicates the compatible software version of CPU Module Logging Configuration Tool.
*5 Data is backed up or restored by using programs (special relay and special register).
*6 This function is not supported in redundant mode.
*7 Support of the program restoration information write selection of writing to the programmable controller while the Process CPU is
stopped and of the file batch online change is as follows: F: 13, S: 1.040S.
*8 The firmware version of the Simple Motion Module is "Ver.05" or later.
*9 Only the standard program is supported.
*10 Online change (inactive SFC block) is supported in F: , S: 1.040S.
*11 Online change (inactive SFC block) is supported in F: 28, S: 1.035M.