30
1 CPU MODULE
*1 When a cable is connected to the USB connector at all times, clamp the cable to prevent a poor connection, moving, and disconnection
by unintentional pulling.
(16) Battery A backup battery to hold clock data and to use the backup power function for the device/label memory
(17) Battery connector pin A pin for connecting a lead wire of the battery
(To save the battery, the lead wire is disconnected from the connector before shipment.)
(18) Cassette cover A cover for the connector where an extended SRAM cassette is inserted ( Page 31 EXTENDED SRAM
CASSETTE, Page 39 Inserting or Removing an Extended SRAM Cassette)
(19) LED cover A cover for the LED indicators, SD memory card slot, and switches. Open this cover and insert or remove an SD
memory card or set the RUN/STOP/RESET switch.
Otherwise, keep the cover closed to prevent entry of foreign matter such as dust.
(20) USB cover A cover for the USB port. Open this cover and connect a USB-compatible peripheral.
Otherwise, keep the cover closed to prevent entry of foreign matter such as dust.
(21) Production information marking Shows the production information (16 digits) of the module.
No. Name Description
To Next Page
Loading...
