Mitsubishi Electric MELSEC iQ-R Series - Page 581

36 ERROR CODES
36.4 List of Error Codes
579
36
3005H Boot function
execution error
• When the boot function is executed,
the security key registered in the CPU
module (or cassette) does not match
the one that locks the boot source
program.
• When the boot function is executed,
the security key is not registered in
the CPU module (or cassette) even
though the boot source program is
locked with the security key.
• The program files and FB files that
are written to an SD memory card
using the memory card operation of
the engineering tool is set to boot
targets.
Stop • Check and correct the security key
setting.
• Delete the boot settings from the
memory card parameter.
• Write the boot target program files
and FB files to the SD memory
card on the CPU module using the
online data operation of the
engineering tool.
Drive/file
information
At power-on, at
RESET
300CH Execution error
of functions
using memory
card
• The firmware update cannot be
executed because the firmware
update file is not stored in the memory
card.
• The automatic restoration function
with the SD CARD OFF button cannot
be executed because the system file
for the function is not stored in the
memory card.
Stop • If the automatic restoration
function with the SD CARD OFF
button cannot be executed, take
either of the following actions.
(1) Check that the system file for
automatic restoration with the SD
CARD OFF button is stored.
(2) Turn on bit 2 of SD955
(Automatic restoration with the
SD CARD OFF button) before
backing up the data.
 At power-on, at
RESET
3010H Data restoration
function
execution error
• The model of the restoration target
CPU module differs from the model of
the backup source CPU module.
Stop • Execute the data restoration
function to the CPU module
whose model is the same as that
of the backup source CPU
module.
• Turn off bit 0 of SD955 to disable
the automatic data restoration
function.
CPU module
data backup/
restoration
folder
information
At power-on, at
RESET
3011H Data restoration
function
execution error
• Reading of backup data from an SD
memory card completed with an error.
Stop • Replace an SD memory card, and
execute the function again.
• The backup data may have been
corrupted. Execute the data
restoration function using another
backup data.
• Turn off bit 0 of SD955 to disable
the automatic data restoration
function.
CPU module
data backup/
restoration
folder
information,
drive/file
information
At power-on, at
RESET
3012H Data restoration
function
execution error
• Writing of backup data to the CPU
built-in memory completed with an
error.
Stop • The possible cause is a hardware
failure of the restoration target
CPU module. Execute the data
restoration function to another
CPU module.
CPU module
data backup/
restoration
folder
information,
drive/file
information
At power-on, at
RESET
3
013
H Data restoration
function
execution error
• The system file does not exist in the
backup data to be restored.
• File(s) in the system file information
does not exist in the folder of the
backed up data.
Stop • The backup data may have been
corrupted. Execute the data
restoration function using another
backup data.
• Turn off bit 0 of SD955 to disable
the automatic data restoration
function.
CPU module
data backup/
restoration
folder
information
At power-on, at
RESET
3014H Data restoration
function
execution error
• Data was restored to the CPU module
where the same data with a file
password has already been stored.
Stop • Delete file passwords, and
execute the CPU module data
backup/restoration function.
• Turn off bit 0 of SD955 to disable
the automatic data restoration
function.
CPU module
data backup/
restoration
folder
information
At power-on, at
RESET
Error
code
Error name Error details and cause Stop/
continue
Action Detailed
information
Diagnostic
timing