Mitsubishi Electric MELSEC iQ-R - Page 127

1 FUNCTIONS
1.4 BACnet Request Function (Read Function)
125
1
4. Check the buffer memory address.
Create a program to set a read target by referring to the format of access blocks for reading. Replace the offset +0 in the
format of access blocks for reading with the buffer memory address displayed with a configuration function. (Page 291
Format of access blocks for reading)
5. Store '1' to the CONTROL of the access block for reading using a program. (The BACnet module sends a
ReadPropertyMultiple service.Page 128 Execution example of the read function)
For the operation of a BACnet module, refer to the following section.
Page 126 Operation of a BACnet module
6. Select [BACnetRequest]  [Read], and click the [Detail] button of the data bock to which the read function is executed.
7. Check the execution result.
If an error occurred, check the row of "Status" and take corrective actions.