APPX
Appendix 6 BACnet Detail Setting List
287
A
I-Am
Parameters for an I-Am service and I-Have service to be sent from a BACnet module can be set in "I-Am".
For the setting method, refer to the following section.
Page 279 Setting method
Time
Parameters for time synchronization with another BACnet device can be set in "Time".
For the setting method, refer to the following section.
Page 279 Setting method
Item Description Initial
value
Data
range
SendIAmIntervalSecond When sending I-Am services periodically, set the cycle within 0 to 600. (Unit: seconds)
When do not to send requests periodically, set '0'.
0 0 to 600
IamIhaveMode Set how to send an I-Am service or I-Have service against the Who-Is service and Who-Has
service received from another BACnet device.
0: RemoteBroadcast
1: GlobalBroadcast
2: LocalBroadcast
3: Unicast
2 0 to 3
IamReturnOnlyOperational Set a condition to send an I-Am service against the Who-Is service received from another BACnet
device.
0: An I-Am service is sent when a SystemStatus property is other than NonOperational.
1: An I-Am service is sent only when a SystemStatus property is Operational.
1 0 to 1
Item Description Initial
value
Data
range
TimeSyncMaster Set whether to synchronize time (send a TimeSynchronization service) with another BACnet device
at the specified time every day.
0: Time synchronization is not performed with the specified time every day.
1: Time synchronization is performed with the specified time every day.
00 to 1
TimeSyncHour When '1' is set to a TimeSyncMaster parameter, specify an hour to synchronize.
(Example) Set '2' to perform time synchronization at 2:10.
00 to 23
TimeSyncMinute When '1' is set to a TimeSyncMaster parameter, specify a minute to synchronize.
(Example) Set '10' to perform time synchronization at 2:10.
15 0 to 59
To Next Page
Loading...
