2 SETTING PARAMETERS
2.1 Parameter Setting Procedure
229
2
2 SETTING PARAMETERS
Various operations can be set by setting parameters using an engineering tool.
2.1 Parameter Setting Procedure
1. Add a BACnet module to an engineering tool.
Navigation window [Parameter] [Module Information] right-click [Add New Module]
2. There are two types of parameter settings: Basic Configuration and Refresh Setting. Select either of the setting in the
tree shown in the following screen.
Navigation window [Parameter] [Module Information] "RJ71BAC96" [Module Parameter]
3. Write the setting to a CPU module using an engineering tool.
[Online] [Write to PLC]
4. The setting is applied by resetting the CPU module, or turning the power OFF and ON.
To Next Page
Loading...
