238
1 FUNCTIONS
1.17 Redundant System Function
11. Write the set parameters to the system A CPU module.
[Online] [Write to PLC]
12. Click the [Yes] button to write to the CPU modules of both systems.
13. Either reset the CPU modules of both systems or power off and on both systems.
In this setting example, default settings are used for the parameters other than those described. For the
parameter setting, refer to the chapter explaining the parameters in this manual. ( Page 241
PARAMETER SETTINGS)
Sending side
Connect the engineering tool to the CPU module on the sending side and set the parameters.
1. Set the CPU module as follows.
[Project] [New]
2. Click the [OK] button to add the module labels of the CPU module.
To Next Page
Loading...
