APPX
Appendix 3 Buffer Memory Areas
167
A
•CH Trigger generation time (Second/Day of the week) (in Q compatible mode)
•CH Trigger generation time (Millisecond) (in Q compatible mode)
• Time units shorter than one millisecond are not recorded.
• When 'CH1 Logging hold request' (Un\G471) is turned on and off, 'CH1 Trigger generation time' (Un\G444
to Un\G448) is cleared to 0.
CH1 Difference conversion trigger
Use this buffer memory area as a trigger to start or stop the difference conversion.
For details on the difference conversion function, refer to the following.
Page 56 Difference Conversion Function
If a value other than the above is set, a difference conversion trigger setting range error (error code: 1A7H) occurs.
■Buffer memory address
The following shows the buffer memory address of this area.
•CH Difference conversion trigger
•CH Difference conversion trigger (in Q compatible mode)
■Starting and stopping the difference conversion
• The difference conversion starts when 'CH1 Difference conversion trigger' (Un\G470) is changed from No request (0) to
Trigger request (1).
• The difference conversion stops when 'CH1 Difference conversion trigger' (Un\G470) is changed from Trigger request (1) to
No request (0).
■Default value
The default value is No request (0) for all channels.
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12 CH13 CH14 CH15 CH16
1157 1161 11 65 1169 1173 1177 1181 1185
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12 CH13 CH14 CH15 CH16
1186 1187 11 88 1189 1190 1191 1192 1193
Setting value Setting content
0 No request
1 Trigger request
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12 CH13 CH14 CH15 CH16
470 670 870 1070 1270 1470 1670 1870 2070 2270 2470 2670 2870 3070 3270 3470
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12 CH13 CH14 CH15 CH16
172 173 174 175 176 177 178 179
To Next Page
Loading...
