Mitsubishi Electric R60AD8-G - Setting in the Intelligent Device Station

210
APPX
Appendix 5 Operation Examples of When the Remote Head Module Is Mounted
Setting in the intelligent device station
Connect the engineering tool to the remote head module of the intelligent device station and set parameters.
1. Create the project with the following settings.
[Project]  [New]
2. Set "Network Required Setting" of "CPU Parameter" of the remote head module as shown below.
[Navigation window]  [Parameter]  [RJ72GF15-T2]  [CPU Parameter]  [Network Required Setting]
3. Add the A/D converter module with the following settings.
[Navigation window]  [Parameter]  [Module Information]  Right-click  [Add New Module]