Mitsubishi Electric R60AD8-G - Chapter 6 Specifications; Performance Specifications

6 SPECIFICATIONS
6.1 Performance Specifications
225
6
6 SPECIFICATIONS
This chapter describes the performance specifications and function list of the R60AD8-G in SIL2 mode.
6.1 Performance Specifications
Performance specifications of the R60AD8-G in SIL2 mode are as follows.
Item Specifications
Number of analog input channels 8 channels
Analog input voltage -10 to 10VDC (Input resistance: 1M)
Analog input current 0 to 20mADC (input resistance 250)
Digital output 16-bit signed binary value (-32768 to 32767)
I/O conversion characteristics, resolution
*1
Analog input range Digital output value Resolution
Voltage 0 to 10V 0 to 32000 312.5V
0 to 5V 156.3V
1 to 5V 125.0V
1 to 5V (extended mode) -8000 to 32767 125.0V
-10 to 10V -32000 to 32000 312.5V
User range setting
(voltage)
50.0V
*2
Current 0 to 20mA 0 to 32000 625.0nA
4 to 20mA 500.0nA
4 to 20mA (extended
mode)
-8000 to 32767 500.0nA
User range setting
(current)
-32000 to 32000 190.6nA
*2
Accuracy (Accuracy of the maximum digital output
value)
*3
Reference accuracy: Within 0.1% (32 digit)
*4
Temperature coefficient: 35ppm/ (0.0035%/)
*5
Accuracy of double input discrepancy detection 0.5 to 5.0%
*10
Common mode characteristics Common mode voltage between input and common ground (input voltage 0V): 500VAC
Common mode voltage rejection ratio (VCM < 500V): 60Hz 107dB, 50Hz 106dB
Conversion speed
*6
12ms/CH
Response time
*7
20ms
SIL2 A/D conversion cycle setting 700 to 32767ms
*8
Control cycle time 12ms
Absolute maximum input Voltage: 15V, Current: 30mA
*9
Isolation method Between I/O terminals and programmable controller power supply: Transformer
Between analog input channels: Transformer
Withstand voltage Between I/O terminals and programmable controller power supply: 500VACrms for 1 minute
Between analog input channels: 1000VACrms for 1 minute
Isolation resistance Between I/O terminals and programmable controller power supply: 10M or higher, at 500VDC
Between analog input channels: 10M or higher, at 500VDC
Number of occupied I/O points 16 points, 1 slot (I/O assignment: Intelligent 16 points)
External interface 40-pin connector
Applicable wire size When A6CON1 and A6CON4
are used
0.088 to 0.3 (28 to 22 AWG) (stranded wire)
When A6CON2 is used 0.088 to 0.24 (28 to 24 AWG) (stranded wire)
Connector for external devices A6CON1, A6CON2, A6CON4 (sold separately)
Internal current consumption (5VDC) 0.33A
External dimensions Height 106mm (Base unit mounting side: 98mm)
Width 27.8mm
Depth 110mm
Weight 0.19kg