Mitsubishi Electric R60AD8-G - When the Module-Specific Backup Parameter Is Not Used

1 FUNCTIONS
1.16 Backing up, Saving, and Restoring Offset/Gain Values
91
1
When the module-specific backup parameter is not used
Back up or restore offset/gain values by one of the following methods.
• Saving and restoring by dedicated instructions
• Saving and restoring by reading from and writing to the buffer memory
With the method above, offset/gain values can be restored to a new module, or the offset/gain values set in one module can
be applied to the other modules in the same system.
• To restore offset/gain values onto a new replaced module:
1. Save offset/gain values.
2. Power off the programmable controller, and replace the
A/D converter module with a new one.
3. Restore the offset/gain values.