Mitsubishi Electric R60AD8-G - Appendix 5 Operation Examples of When the Remote Head Module Is Mounted; System Configuration Example

206
APPX
Appendix 5 Operation Examples of When the Remote Head Module Is Mounted
Appendix 5 Operation Examples of When the Remote
Head Module Is Mounted
This section describes operation examples of when the remote head module is mounted.
System configuration example
The following system configuration is used to explain an example of operation.
*1 In the RX/RY setting of the master station, set 1000H to 100FH as the start I/O number of the A/D converter module.
(1) Master station (Network number 1, station number 0)
• Power supply module: R61P
• CPU module: R04CPU
• Master/local module: RJ71GF11-T2 (Start I/O number: 0000H to 001FH)
• Input module: RX10 (Start I/O number: 0020H to 002FH)
(2) Intelligent device station (Network number 1, station number 1)
• Power supply module: R61P
• Remote head module: RJ72GF15-T2
• A/D converter module: R60AD8-G (Start I/O number: 0000H to 000FH
*1
)
(1) (2)