Mitsubishi Electric R60AD8-G - Page 78

76
1 FUNCTIONS
1.12 Logging Function
Setting procedure
To use the logging read function, both the logging read function and the interrupt setting must be set.
1. Set "Condition target setting" to "Logging read".
[Navigation window]  [Parameter]  [Module Information]  Module model name  [Module Parameter]  [Interrupt
setting]
2. Set "A/D conversion enable/disable setting" to "A/D conversion enable".
[Navigation window]  [Parameter]  [Module Information]  Module model name  [Module Parameter]  [Basic
setting]  [A/D conversion enable/disable setting]
3. Set "Logging enable/disable setting" to "Enable".
[Navigation window]  [Parameter]  [Module Information]  Module model name  [Module Parameter] 
[Application setting]  [Logging function]
4. Set the target data to be logged in "Logging data setting".
5. Set the cycle to store the logging data to "Logging cycle setting value".
6. Set "Read interrupt enable/disable setting" to "Enable".
7. Set the number of logging points that generate a read interrupt in "Logging read points setting value".
Setting example
Ex.
When an interrupt program that is executed when the data of 'CH1 Logging read points monitor value' (U0\G440) is logged is
assigned to the interrupt pointer I50
• Label settings
Classification Label name Description Device
Module Label RCPU.stSM.bAfter_RUN1_Scan_ON ON for one scan after RUN SM402
R60ADG_1.unInterruptFactorMask_D[0].0 Interrupt factor mask U0\G124
R60ADG_1.unInterruptFactorDetectionFlag_D[0].0 Interrupt factor detection flag U0\G4
R60ADG_1.unInterruptFactorResetRequest_D[0].0 Interrupt factor reset request U0\G156
R60ADG_1.stnMonitor_D[0].wThisLoggingLoadPointer_D CH1 Current logging read pointer U0\G438
R60ADG_1.stnMonitor_D[0].uLoggingLoadPointsMonitorValue_D CH1 Logging read points monitor
value
U0\G440
Labels to be
defined
Define global labels as shown below: