Mitsubishi Electric R64MTCPU - Page 235

4 OPERATION CONTROL PROGRAMS
4.16 Advanced Synchronous Control Dedicated Function
233
4
■Device assignment of the cam auto-generation data for the rotary cutter cam
When the synchronous position adjustment is set to 0, the cam pattern of which the sheet center is in the synchronous section
is created.
Offset Name Description Range
+0 Resolution Set the cam resolution for generating the cam. 256/512/1024/2048/4096/8192/
16384/32768
+1
+2 Auto-generation
option
• Select the trapezoidal acceleration/deceleration system or the S-curve
acceleration/deceleration system with bit 0.
• Select the diameter or the cycle length for the synchronous axis length with bit 1.
• Set 0 for bits 2 to 15.
• Bit 0: Acceleration/
deceleration system
0: Trapezoidal acceleration/
deceleration
1: S-curve acceleration/
deceleration
• Bit 1: Synchronous axis
length setting
0: Diameter
1: Cycle length
+3 Synchronous section
acceleration ratio
Set when the synchronous speed in the synchronous section needs to be adjusted.
The speed is "Synchronous speed  (100% + Acceleration ratio)" in the
synchronous section.
-5000 to 5000[0.01%]
+4 Sheet length Set the sheet length. 1 to 2147483647
[(Optional) Same units]
+5
+6 Sheet
synchronization width
• Set the sheet synchronization width (seal width).
• When the synchronous speed section for retracting is required in front of and
behind the sheet synchronization width, add the retracting width.
1 to 2147483647
[(Optional) Same units]
+7
+8 Synchronous axis
length
• Set the rotary cutter axis length.
• When the synchronous axis length of the auto-generation option is set to the
diameter, "Cycle length = setting value  .
• When the synchronous axis length of the auto-generation option is set to the
cycle length, "Cycle length = setting value".
• For diameter setting
1 to 680000000
• For cycle length setting
1 to 2147483647
[(Optional) Same units]
+9
+10 Synchronous position
adjustment
• Set the position adjustment of the synchronous section.
-: The synchronous section is adjusted to the sheet start side.
0: The center of the sheet is in the synchronous section.
+: The synchronous section is adjusted to the sheet end side.
• Set the value within one-half of the sheet length.
-1073741823 to 1073741823
[(Optional) Same units]
+11
+12 Acceleration/
deceleration width
• Set the sheet width (one side) of the acceleration/deceleration area.
• When a negative value is set, the acceleration/deceleration width is determined to
be the maximum.
0 to 2147483647
[(Optional) Same units]
• For a value other than the
above, the acceleration/
deceleration width is
determined to be the
maximum.
+13
+14 Number of cutter Set the number of cutter. 1 to 256
+15 Asynchronous speed
result
When the cam auto-generation is successfully performed, the asynchronous speed
is stored as the ratio to the synchronous speed.
0 to 65535 [0.01 times]