Mitsubishi Electric R64MTCPU - Reset a Status Storage Device: MVFIN

254
4 OPERATION CONTROL PROGRAMS
4.17 Vision System Dedicated Function
Reset a status storage device: MVFIN
Setting data
■Usable data
: Usable
■Description, data type of result
Processing details
• The status storage device value set in the Ethernet communication line setting parameter specified with (S) is 20 (reception
enabled).
• When a trigger is issued to the vision system, the status storage device is reset by MVFIN instruction in advance, and the
process completion for trigger needs to be detected.
Operation error
An operation error will occur if:
• The (S) data is outside the range of 1 to 32.
• The vision system specified with (S) has not been logged on.
• The vision system parameter setting is different from the setting on the vision system.
• The status storage device value set in the Ethernet communication line setting parameter is not 20 (reception enabled), 40
(Image data reception completed), or 50 (value cell reception completed).
Program example
■Program which resets the status storage device for the vision system (camera) 1
Format Number of basic steps Usable steps
F/FS G
MVFIN(S) 6 
Setting
data
Usable Data
Bit
device
Word device Constant Calculation
expression
Bit
conditional
expression
Comparison
conditional
expression
16-bit
integer
type
32-bit
integer
type (L)
64-bit
floating
point
type (F)
16-bit
integer
type
(K/H)
32-bit
integer
type
(K/H, L)
64-bit
floating
point
type (K)
(S)   
Setting data Description Data type of result
(S) Vision system (camera) No. to reset the status storage device (1 to 32) 
MVFIN K1