Mitsubishi Lancer Evolution VI - Service Specifications; Lubricant; General; Outline of Change

REAR AXLE – General / Service Specifications / Lubricant
27-2
GENERAL
OUTLINE OF CHANGE
D The descriptions of the service procedures for the AYC system including the troubleshooting using
an MUT-II tester has been incorporated.
SERVICE SPECIFICATIONS
<Vehicles with AYC>
Items Standard value Limit
Rear axle total backlash mm – 5
Pressure generated by hydraulic unit MPa 0 – 1.6 –
Wheel bearing axial play mm – 0.05
Wheel bearing rotation starting torque Nm – 1.0 or less
LUBRICANT
<Vehicles with AYC>
Items Specified lubricant Capacity
Gear oil Torque
transfer
di
ff
erential
Differential Hypoid gear oil API classification GL-5 or higher
SAE viscosity No. 90, 80W
0.41 ± 0.02 ȏ
diff
eren
ti
a
l
Torque transfer
mechanism
MITSUBISHI GENUINE DIA QUEEN AYC FLUID
0.70
)0
*0.05
ȏ
Hydraulic piping fluid Dia Queen ATF SPII or equivalent 1 ȏ
Torque transfer mechanism oil seal lips Vaseline As required