CHASSIS ELECTRICAL – Headlamp
54-34
ON-VEHICLE SERVICE
HEADLAMP AIMING
Bring the vehicle in the following conditions before aiming
the headlamp.
D Check the tires for inflation pressure. Pump them up if
necessary to the labeled pressure level.
D Set the vehicle unladen on a level floor.
D Place one person (approximately 55 kg) on the driver’s
seat.
1. Position the tester so that its converging lens faces the
high-beam lamp (f marked) center to center at a distance
of 3 m from each other.
2. Aim the headlamps to appropriate standard values using
the aiming adjustment screw.
Face the face 3 m apart from each other
Lamp center
16M0001
Horizontal adjustment
Vertical
adjust-
ment
To Next Page
Loading...
