GENERAL – Brake Test
00-21
BRAKE TEST
In order to stabilize the viscous coupling’s dragging force,
the brake test should always be conducted after the
speedometer test.
FRONT WHEEL MEASUREMENTS
1. Place the front wheels on the brake tester.
2. Perform the brake test.
Caution
The rear wheels should remain on the ground.
3. If the brake dragging force exceeds the specified value,
jack up the vehicle and manually rotate each wheel to
check the rotation condition of each wheel.
NOTE
If the brake dragging force exceeds the specified value,
the cause may be the effect of the viscous coupling’s
dragging force, so jack up the front wheels and check
the rotation condition of the wheels in this state for no
effect by the viscous coupling’s dragging force.
REAR WHEEL MEASUREMENTS
After placing the rear wheels on the brake tester, follow the
same procedures as for the front wheel measurements.
Brake tester
To Next Page
Loading...
