EXTERIOR – Washer Tank and Hoses
51-6
WASHER TANK AND HOSES
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operations
D Washer Fluid Draining and Pouring
D Trunk Side Trim (L.H.) Removal and Installation
<GSR>
2
1
3
5
4
6
To rear washer
To windshield washer
5 Nm
6
6
5
5
6
Washer tank removal steps
1. Washer tank assembly
2. Washer tank bracket
"AA 3. Washer motor (rear)
"AA 4. Washer motor (front)
Washer hose removal steps
D Front seat and rear seat
D Floor carpet
5. Washer hose
6. Joint
INSTALLATION SERVICE POINT
"AA WASHER MOTOR (FRONT) / WASHER MOTOR
(REAR) INSTALLATION
When installing the washer motors, pay special attention to
the following:
1. Connector shape (front: 2-pole round connector, rear:
2-pole square connector)
2. Connection of washer tubes
To Next Page
Loading...
