High power operation
The high power operation adjusts the room temperature quickly to a pleasant level by increasing the operation
capacity.
The high power operation continues for 15 minutes at the maximum and returns to the normal operation automatically.
When the operation mode is changed, the high power operation returns to the normal operation, too.
High power operation must be set to the F1
or F2 switch (☞page 63).
High power operation is set to the F1
switch as the factory setting.
1
Push the
F1
(
F2
) switch to start the high power operation.
■Operation will start when the
F1
(
F2
) switch is pushed, even if
Run/Stop
switch is off.
■High power operation is only allowed when Heating or Cooling is selected for
the operation mode.
Message “In operation for high power.” is displayed on the R/C
screen, and “—, —°C” is displayed on the Set temp button during
the high power operation.
■Set temp and change fan speed operations are disabled during high power
operation.
2
High power operation is terminated when you perform one of the
following.
・
When you terminate through a
Run/Stop
operation
・
When you change the operation mode
・
When15 minutes have elapsed since the high power operation
started
・
When you terminate the high power operation with the
F1
(
F2
) switch
Menu
Direction
Cooling
15：50
(Mon)
F1: High power
Timer
In operation for high power.
Set temp
F2: Energy-saving
To Next Page
Loading...
Need help?
General
